9.0

Remote controlling Cubase
The Generic Remote device
431
Therefore, when you are using a device without touch-sensitive controls and want to replace
existing automation data, pay attention to the following:
•
If you activate Write mode and move a control on the remote control device, all data
for the corresponding parameter is replaced from the position where you moved the
control, up to the position where playback is stopped.
In other words, as soon as you move a control in Write mode, it remains “active” until
you stop playback.
•
Make sure that you move only the controller you want to replace.
Assigning remote key commands
For some remote devices, you can assign any Cubase function (to which a key command can
be assigned) to generic buttons, wheels, or other controls.
PROCEDURE
1. Open the Device Setup dialog and select your remote device.
On the right side of the window you will find a table. This is where you assign
commands.
2. Use the Button column to locate a remote device control or button to which you want to
assign a Cubase function.
3. Click in the Category column for the control and select one of the Cubase function
categories from the pop-up menu.
4. Click in the Command column and select the desired Cubase function from the pop-up
menu.
The available items on the pop-up menu depend on the selected category.
5. Click “Apply” when you are done.
Click “Reset” to revert to the default settings.
RESULT
The selected function is now assigned to the button or control on the remote device.
A note about remote controlling MIDI tracks
While most remote control devices will be able to control both MIDI and audio channels in
Cubase, the parameter setup may be different. For example, audio-specific controls (such as
EQ) will be disregarded when controlling MIDI channels.
The Generic Remote device
If you have a generic MIDI controller, you can use this for remote control of Cubase by setting
up the Generic Remote device:
PROCEDURE
1. Open the Device Setup dialog on the Devices menu.
If the Generic Remote device is not on the Devices list, you need to add it.
2. Click the “+” sign in the top left corner and select the “Generic Remote” device from
the pop-up menu.