10.0

2. In the Project Time Displays section, open the Sample Rate pop-up menu and select a
sample rate.
Setting up Digital Audio Connections
PROCEDURE
1. Select Studio > Audio Connections.
2. Click the Inputs tab, and click Add Bus.
3. In the Add Input Bus dialog, congure the bus.
4. Click Add Bus.
5. Click the Outputs tab, and click Add Bus.
6. In the Add Output Bus dialog, congure the bus.
7. Click Add Bus.
8. Repeat these steps for all applications.
Set up the same conguration in all applications. If you have 4 stereo output busses on
computer 1, you want 4 stereo input busses on computer 2, etc.
9. Route the applications to the digital inputs and outputs.
RELATED LINKS
Audio Bus Setup on page 16
Audio Connections Window on page 21
Verifying the Digital Connection
PROCEDURE
1. Connect an audio source to your audio interface.
2. Start recording, playing back, and mixing.
3. On computer 1, play back some audio.
4. Select Studio > MixConsole, and route the channel that contains the audio material to one
of the digital output busses.
5. On computer 2, select Studio > MixConsole, and locate the corresponding digital input
bus.
The audio that is played back should now appear in the application running on computer
2, and the input bus level meters should move.
RESULT
You have now veried that the digital connection works as it should. You can reverse this
procedure so that computer 2 plays back and computer 1 listens.
Activating VST System Link
You must activate VST System Link on all network computers to be able to work with VST
System Link.
PROCEDURE
1. Select Transport > Project Synchronization Setup, and on the Sources tab, activate VST
System Link as the timecode source.
2. Select Studio > Studio Setup.
VST System Link
Activating VST System Link
645