10.0

If you Alt-click in the upper right corner of the editor, you can compress or expand the
right part of the curve. This allows you to compress or expand the event values at the end
of the curve.
6 Tilt Right
If you click in the upper right corner of the editor, you can tilt the right part of the curve.
This allows you to tilt the event values at the end of the curve upwards or downwards.
7 Scale Around Relative Center
If you Alt-click in the middle right border of the editor, you can scale the curve relative to
its center. This allows you to raise or lower the event values horizontally around the center
of the editor.
8 Scale Around Absolute Center
If you click in the middle right corner of the editor, you can scale the curve absolute to its
center. This allows you to raise or lower the event values horizontally around the center of
the editor.
9 Stretch
If you click on the lower border of the editor, you can stretch the curve horizontally. This
allows you to move the event values of the curve to the left or to the right.
Editing in the Controller Lane Editor
The controller lane editor allows you to perform additional scaling operations for selection
ranges on controller curves.
● To open the controller lane editor, use the Object Selection tool to create a selection
rectangle on the controller lane, encompassing the controller events that you want to edit.
For velocity lanes, press Alt to get the Object Selection tool.
● To switch the controller lane editor to vertical scaling mode, press Shift and click on any of
the smart controls.
● To move the whole selection up/down or left/right, click on a controller event inside the
editor and drag the curve.
● To restrict the direction to horizontal or vertical movement, depending on the direction in
which you start dragging, press Ctrl/Cmd when dragging.
NOTE
Snap is taken into account when moving controller curves horizontally.
Moving Events in the Controller Display
You can move events in a controller lane.
PROCEDURE
1. Select the events that you want to move with the Object Selection tool.
You can also click and drag to create a selection rectangle that encompasses the events
that you want to move.
2. Click on a curve point inside the selection and drag the events.
RESULT
The events inside the selection are moved to the new position. Snap is taken into account.
MIDI Editors
Common MIDI Editor Functions
521