9.5

Table Of Contents
Tracks
FX Channel Tracks
If this option is activated the program creates scale events automatically.
Mapping Offset
Allows you to specify an offset value to make sure that chord events also affect the
MIDI notes that have been triggered too early (enter a negative value) or too late
(enter a positive value).
Chord Track Inspector Sections
Apart from the basic track settings that are always shown, the chord track provides other
Inspector sections. These are described in the following sections.
Notepad
Allows you to enter notes about the track.
Chord Track Controls
The Track List for the chord track contains controls and parameters that allow you to edit the
chord track.
The track list for chord tracks contains the following controls:
Mute
Mutes the track.
Select Track for Auditioning
Allows you to select a track for auditioning the chord events.
Record Enable
Allows you to record chord events.
Resolve Display Conflicts
Allows you to show all chord events on the track properly, even at low horizontal
zoom levels.
Show Scales
Allows you to show the scale lane in the lower part of the chord track.
FX Channel Tracks
You can use FX channel tracks for adding send effects. Each FX channel can contain up to eight
effect processors. By routing sends from an audio channel to an FX channel, you send audio
from the audio channel to the effects on the FX channel. You can place FX channel tracks in
a special FX channel folder, or in the track list, outside a FX channel folder. Each FX channel
96