9.5

Table Of Contents

MIDI Editors

Key Editor Operations

The Object Selection tool automatically switches to the Draw tool when you move the

pointer into the controller display.

When you move the pointer in the controller lane, the corresponding event type value is

displayed below the event type name.

In velocity mode, no new controller events are added this way.

●

To edit the values of any other event type in the controller display, press Alt and drag, or

use the Draw tool or the Line tool and drag.

When you move the pointer inside a controller lane, the event type value changes

corresponding to the pointer movement. The event type value is displayed below the event

type name, left of the controller display.

●

If there is more than one note at the same position, their velocity bars overlap on the

controller lane. If none of the notes are selected, all notes at the same position are set to

the same velocity value when you draw.

To edit the velocity of only one of the notes at the same position, first select the note in the

note display.

●

To select all events on a controller lane, open the Controller Lane Setup pop-up menu

and select the Select all Controller Events option.

●

To use the Object Selection tool to select events in the velocity controller display, press

Alt.

●

To cut, copy, and paste events in the controller display select the event and select Edit>

Cut/Copy/Paste.

When pasting events, the events on the clipboard are added, starting at the project cursor

position and maintaining their relative distances. If a pasted event ends up at the same

position as an existing event of the same type, the old event is replaced.

NOTE

If the speaker icon (Acoustic Feedback) is activated on the toolbar, the notes are played back

when you adjust the velocity. This allows you to audition your changes.