9.5

Table Of Contents

MixConsole

MixConsole Window

3. Click to the left of the low-cut filter to activate the low-cut filter. You have the following

options:

●

Drag the slider to adjust the cutoff frequency.

The available range spans from 20 Hz to 20 kHz.

●

Click Select Filter Slope on the right of the low-cut filter to select a filter slope.

You can choose between 6, 12, 24, 36, and 48 dB. The default value is 12 dB.

RESULT

The changed settings are visible in the curve display. If you deactivate the high-cut and low-cut

filters, the filter curves are removed from the display. Bypassed high-cut and low-cut filters are

displayed in a different color.

Making Input Gain Settings

The Pre-Gain slider allows you to change the level of a signal before it reaches the EQ and the

effects section. This is useful as the level going into certain effects can change the way the signal

is affected. A compressor, for example, can be driven harder by raising the input gain. Gain can

also be used to boost the level of poorly recorded signals.

PROCEDURE

1. On the MixConsole toolbar, click Racks and activate Pre (Filters/Gain/Phase) to show the

Pre rack above the fader section.

2. Drag the Gain slider to the left or to the right to cut or boost the gain.

Making Phase Settings

Each audio-related channel and input/output channel has a Phase button that allows you to

correct the phase for balanced lines and microphones that are wired backwards or that are out

of phase due to their positioning.

PROCEDURE

1. On the MixConsole toolbar, click Racks and activate Pre (Filters/Gain/Phase) to show the

Pre rack above the fader section.

2. Activate Phase to invert the phase polarity for the signal.

Inserts

The Inserts rack for audio-related channels features insert effect slots that allow you to load

insert effects for a channel. For MIDI channels you can load MIDI inserts.

For further information, see the separate document Plug-in Reference.