9.0

Table Of Contents

Included Effect Plug-ins

Modulation Plug-ins

Filter Lo/Hi

Allow you to roll off low and high frequencies of the effect signal.

NOTE

If side-chaining is supported, the modulation can also be controlled from another signal

source via the side-chain input. If the side-chain signal exceeds the threshold, the

modulation is controlled by the side-chain signal’s envelope. For a description of how to set

up side-chain routing, see the Operation Manual.

Cloner

This plug-in adds up to 4 detuned and delayed voices to the signal, for rich modulation and

chorus effects.

Cubase

Elements

Cubase

Artist

Cubase

Pro

Nuendo NEK

Included with – – – – X X –

Voices

Sets the number of voices (up to 4). For each voice, a Detune and a Delay slider

are available in the right half of the panel.

Spatial

Spreads the voices across the stereo spectrum. Turn clockwise for a deeper

stereo effect.

Mix

Sets the level balance between the dry signal and the wet signal. If the effect

is used as a send effect, set this parameter to the maximum value as you can

control the dry/effect balance with the send.

Output (-12 to 12

dB)

Sets the output gain.

Detune slider (1 to 4)

Controls the relative detune amount for each voice. Positive and negative values

can be set. A value of zero means no detune for that voice.