9.0

Included Effect Plug-ins
Filter Plug-ins
Selecting New Patterns
• Patterns are saved with the project, and up to 8 different cutoff and resonance patterns
can be saved internally. Both the cutoff and resonance settings are saved together in
the 8 pattern slots.
• Use the Pattern Select knob below the Resonance grid to select a new pattern. New
patterns are all set to the same step value by default.
StepFilter Parameters
Base Cutoff
Sets the base filter cutoff frequency. Values set in the Cutoff grid are relative to
the Base Cutoff value.
Base Resonance
Sets the base filter resonance. Values set in the Resonance grid are relative to
the Base Resonance value.
NOTE
Very high Base Resonance settings can produce loud ringing effects at certain
frequencies.
Glide
Applies glide between the pattern steps, causing values to change more
smoothly.
Filter mode
Use this slider to select a filter mode: low-pass, band-pass, or high-pass (from
left to right).
Sync
If the Sync button to the right of the Sync pop-up menu is activated (yellow), the
pattern playback is synchronized to the project tempo.
Use the pop-up menu to set the pattern beat resolution, that is, the note values
the pattern plays in relation to the tempo (1/1 to 1/32, straight, triplet, or dotted).
Output
Sets the output level.
Mix
Sets the level balance between the dry signal and the wet signal.
Creating Variations for StepFilter Patterns
You can copy a pattern of the StepFilter to another pattern slot. This is useful for creating
variations on a pattern of this plug-in.
PROCEDURE
1. Select the pattern that you want to copy.
2. Click the Copy button.
78