9.0

Included Effect Plug-ins
EQ Plug-ins
Auto Listen for Filters
If this option is activated and you edit a parameter of a band, the corresponding
frequency range is isolated. This helps you to focus on a particular frequency
range and allows you to locate unwanted frequencies in your audio.
Global Settings
Opens the settings dialog for the spectrum display.
Show/Hide Keyboard
Shows/Hides the keyboard below the graphical editor.
On the keyboard, color indicators reflect the center frequencies of all active
equalizer bands. You can adjust the frequency of a band by dragging its color
indicator. If you drag the color indicator of a band to a key, the band is set to its
exact frequency.
Output
Adjusts the overall output level.
Band Settings
On/Off
Activates/Deactivates the corresponding band.
Processing Switches
Allow you to switch between left/right, stereo, and mid/side processing. In Left/
Right or Mid/Side processing mode, you can make different settings for the two
channels.
NOTE
This setting is only available for stereo tracks.
Linear Phase
Activates/Deactivates linear phase mode for the corresponding band.
Linear phase mode avoids unwanted frequency dependent phase shifts of the
audio signal that might occur with standard minimum phase equalizing.
NOTE
• Linear phase mode leads to an increase in latency.
• In rare cases, for example, when using low cut filtering with a high slope
for bass signals, also an unwanted pre-ringing effect may be audible.
70