9.0

Included Effect Plug-ins
EQ Plug-ins
Each band can be attenuated or boosted by up to 12 dB, allowing for fine control of the
frequency response. In addition, there are several preset modes available that can add color
to the sound of GEQ-10/GEQ-30.
You can draw response curves in the main display by clicking and dragging with the mouse.
You have to click one of the sliders before you drag across the display.
At the bottom of the window, the individual frequency bands are shown in Hz. At the top of the
display, the amount of attenuation/boost is shown in dB.
Output
Sets the overall gain of the equalizer.
Flatten
Resets all the frequency bands to 0 dB.
Range
Allows you to adjust how much a set curve cuts or boosts the signal.
Invert
Inverts the current response curve.
Mode pop-up menu
This pop-up menu allows you to set the filter mode that determines how the
various frequency band controls interact to create the response curve.
EQ Modes
The Mode pop-up menu in the lower right corner allows you to select an EQ mode, which add
color or character to the equalized output in various ways.
True Response
Applies serial filters with an accurate frequency response.
Digi Standard
In this mode, the resonance of the last band depends on the sample rate.
Classic
Applies a classic parallel filter structure where the response does not follow the
set gain values accurately.
VariableQ
Applies parallel filters where the resonance depends on the amount of gain.
ConstQ u
Applies parallel filters where the resonance of the first and last bands depends
on the sample rate.
ConstQ s
Applies parallel filters where the resonance is raised when boosting the gain and
vice versa.
66