9.0

Included Effect Plug-ins
Dynamics Plug-ins
Center (50 to 20000 Hz)
If the Side-Chain button is activated, this sets the center frequency of the filter.
Q-Factor
If the Side-Chain button is activated, this sets the resonance or width of the filter.
Monitor
Allows you to monitor the filtered signal.
Attack (0.1 to 100 ms)
Determines how fast the compressor responds to signals above the set
threshold. If the attack time is long, more of the early part of the signal passes
through unprocessed.
Hold (0 to 2000 ms)
Determines how long the gate remains open after the signal drops below the
threshold level.
Release (10 to 1000 ms or Auto mode)
Sets the time after which the gate closes after the set Hold time. If the Auto
button is activated, the plug-in automatically finds the best release setting for the
audio material.
Range
Adjusts the attenuation of the gate when it is shut. If Range is set to minus
infinite , the gate is completely shut. The higher the value, the higher the level
of the signal that passes through the shut gate.
Input Gain Meter
Shows the input gain.
Compressor Section
The compressor reduces the dynamic range of the audio, making softer sounds louder or
louder sounds softer, or both. The compressor features a separate display that graphically
illustrates the compressor curve shaped according to your settings.
Threshold (-60 to 0 dB)
Determines the level where the compressor kicks in. Only signal levels above the
set threshold are processed.
Ratio
Sets the amount of gain reduction applied to signals above the set threshold. A
ratio of 3:1 means that for every 3 dB the input level increases, the output level
increases by 1 dB.
Make-Up (0 to 24 dB or Auto mode)
Compensates for output gain loss, caused by compression. If the Auto button is
activated, the knob becomes dark and the output is automatically adjusted for
gain loss.
62