9.0

Included Effect Plug-ins
Delay Plug-ins
Delay
If tempo sync is activated, this sets the base note value for the delay. If tempo
sync is deactivated, the delay time can be set freely in milliseconds.
Delay – Sync
Activates/Deactivates tempo sync for the Delay parameter.
Rate
If tempo sync is activated, this is where you specify the base note value for
tempo-syncing the effect (1/1 to 1/32, straight, triplet, or dotted).
If tempo sync is deactivated, the modulation speed can be set freely with the Rate
knob.
Rate – Sync
Activates/Deactivates tempo sync for the Rate parameter.
Width
Sets the amount of delay modulation. This allows you to create a vibrato or
chorus-like effect.
Feedback
Sets the number of repeats for the delay.
Drive
Adds distortion to the feedback loop. The longer the feedback, the more the delay
repeats are distorted over time.
Mix
Sets the level balance between the dry signal and the wet signal. If the effect
is used as a send effect, set this parameter to the maximum value as you can
control the dry/effect balance with the send.
Nudge
Clicking this button once momentarily speeds up the audio coming into the plug-
in, simulating the nudge command of analog tape machines.
Signal path graphic and Filter position
The filter can either be placed in the feedback loop of the delay or in the output
path of the effect (after the Drive and Feedback parameters). To switch between
the loop and output positions, click in the Filter section displayed in the graphic
or click on the Position field at the bottom right of the graphic.
Filter type (in graphic display)
Allows you to select a filter type. You can choose between a low-pass, band-pass,
and high-pass filter.
5