9.0

Included Effect Plug-ins
Distortion Plug-ins
• To activate/deactivate the equalizer, click the pedal-like On/Off button. If the equalizer
is active, the LED next to the button is lit.
• To activate/deactivate an equalizer band, click the corresponding Gain knob. If a band
is active, the LED to the left of the Gain knob is lit.
• To tune your guitar strings, click the pedal-like On/Off button to activate Tuner and
play a string. If the correct pitch is displayed and the row of LEDs below the digital
display is green, the string is tuned correctly.
If the pitch is too low, red LEDs are lit on the left. If the pitch is too high, red LEDs are
lit on the right. The more LEDs are lit, the lower/higher is the pitch.
• To mute the output signal of the plug-in, click the pedal-like Master button. If the
output is muted, the LED is not lit. Use this to tune your guitar in silence, for example.
• To change the volume of the output signal, use the Level control on the Master page.
•
NOTE
Master EQ functions only when a cabinet is selected.
Configuration
On the Configuration page, you can specify whether you want to use VST Bass Amp in stereo
or in mono mode.
• To process the pre-effects, the amplifier, and the cabinets in full stereo mode, make
sure that the plug-in is inserted on a stereo track, and activate the Stereo button.
• To use the effect in mono-mode, make sure that the plug-in is inserted on a mono
track, and activate the Mono button.
NOTE
In stereo mode, the effect requires more processing power. Use mono configuration on a
stereo track to save processing power.
View Settings
You can choose between 2 views: the default view and a compact view, which takes up less
screen space.
In the default view, you can use the buttons at the top of the plug-in panel to open the
corresponding page in the display section above the amp controls. You can horizontally resize
the plug-in panel by clicking and dragging the edges or corners.
In the compact view, the display section is hidden from view. You can change the amp
settings and switch amps or cabinets using the mouse wheel.
Using the Smart Controls
Smart controls become visible on the plug-in frame when you move the mouse pointer over
the plug-in panel.
Switching between Default and Compact View
• To toggle between the different views, click the down/up arrow button (Show/Hide
Extended Display) at the top center of the plug-in frame.
35