9.0

Included Effect Plug-ins
Distortion Plug-ins
At the top of the plug-in panel, the following buttons open different pages in the display
section of the plug-in panel: Pre-Effects, Amplifiers, Cabinets, Post-Effects, Microphones,
Configuration, and Master.
These buttons are arranged according to the position of the corresponding elements in the
signal chain.
Below the display section, the selected bass amplifier is displayed. The color and texture of
the area below the bass amp indicate the selected cabinet.
Pre/Post-Effects
On the Pre-Effects and Post-Effects pages, you can select up to six common bass effects. On
both pages, the same effects are available, the only difference being the position in the signal
chain (before or after the bass amplifier). On each page, every effect can be used once.
Each effect features an On/Off button known from stompbox effects, as well as individual
parameters.
Wah Wah
Pedal – Controls the filter frequency sweep.
Envelope Filter
Range – Determines the frequency range.
Q-Factor – Sets the intensity of the envelope filter effect.
Sensitivity – Determines how sensitive the effect reacts to the instrument level.
Attack – Determines how quickly an effect reacts to the input signal.
Mix – Sets the level balance between the dry signal and the wet signal.
Type – Sets the filter type.
Release – Determines how quickly the effect fades after the input signal stops.
28