9.0

Included VST Instruments
Spector
Aftertouch
Aftertouch, or channel pressure, is MIDI data sent when pressure is applied
to a keyboard after the key has been struck, and while it is being held down or
sustained. Aftertouch is often routed to control filter cutoff, volume, and other
parameters to add expression.
Key Pitch Tracking
This can change parameter values linearly according to where on the keyboard
you play.
Assign a Controller to a Parameter
PROCEDURE
1. Click in the Mod Dest box for one of the controllers.
A pop-up menu appears in which all possible modulation destinations are shown. All
Sound parameters as well as most LFO and Envelope parameters are available as
destinations.
2. Select a destination.
The selected modulation destination is now shown in the list. Beside the destination, a
default value (50) has been set. The value represents the modulation amount when the
controller is at its full range.
•
You can set positive and negative modulation values by clicking on the value in
the list, typing in a new value, and pressing Enter.
To enter negative values, type a minus sign followed by the value.
3. Using the same basic method, you can add any number of modulation destinations for
the controllers.
They are all listed in the Mod Dest box for each controller.
•
To remove a modulation destination, click on its name in the list and select Off
from the pop-up menu.
Effects (EFX) Page
This page features three separate effect units: Distortion, Delay, and Modulation (Phaser/
Flanger/Chorus). The Effect page is opened by clicking the EFX button at the top of the lower
half of the control panel.
• Each separate effect section is laid out with a row of buttons that determine the effect
type or characteristic and a row of sliders for making parameter settings.
• To activate an effect, click the Active button so that a dot appears.
Clicking again deactivates the effect.
249