9.0

Included VST Instruments
Prologue
The selected modulation destination is now shown in the list. Beside the destination, a
default value (50) has been set. The value represents the modulation amount when the
controller is at its full range.
•
You can set positive and negative modulation values by clicking on the value in
the list, typing in a new value, and pressing Enter.
To enter negative values, type a minus sign followed by the value.
3. Using the same basic method, you can add any number of modulation destinations for
the controllers.
They are all listed in the Mod Dest box for each controller.
•
To remove a modulation destination, click on its name in the list and select Off
from the pop-up menu.
Effects (EFX) Page
This page features three separate effect units: Distortion, Delay, and Modulation (Phaser/
Flanger/Chorus). The Effect page is opened by clicking the EFX button at the top of the lower
half of the control panel.
• Each separate effect section is laid out with a row of buttons that determine the effect
type or characteristic and a row of sliders for making parameter settings.
• To activate an effect, click the Active button so that a dot appears.
Clicking again deactivates the effect.
Distortion
You can choose between 4 basic distortion characteristics:
• Distortion provides hard clipping distortion.
• Soft Distortion provides soft clipping distortion.
• Tape Emulation produces distortion similar to magnetic tape saturation.
• Tube Emulation produces distortion similar to valve amplifiers.
Drive
Sets the amount of distortion by amplifying the input signal.
Filter
Sets the crossover frequency of the distortion filter. The distortion filter consists
of a low-pass filter and a high-pass filter with a cutoff frequency equal to the
crossover frequency.
236