9.0

Included VST Instruments
Mystic
Waveform Pop-up Menu
The pop-up menu at the bottom of the waveform section (the central box at the top of the
panel) allows you to select a basic waveform to be sent through filter contour A. The options
are especially suited for use with the spectrum filter.
Cut
Offsets the frequency of the filter contour, working somewhat like a cutoff control
on a standard synth filter. To use the filter contour in its full frequency range, set
Cut to its maximum value.
Morph
Adjusts the mix between the two signal paths: waveform A spectrum contour A
and waveform B spectrum contour B.
Coarse
Offsets the pitch for the impulse sound. In a typical string setup, when the
impulse sound is very short, this does not change the pitch of the final sound, but
the tonal color.
Raster
This removes harmonics from the impulse sound. As the harmonic content of the
impulse sound is reflected in the comb filter sound, this changes the final timbre.
Comb Filter Sound Parameters
Damping
This is a 6 dB/oct low-pass filter that affects the sound being fed back into the
comb filters. This means the sound becomes gradually softer when decaying,
that is, high harmonics decay faster than the lower harmonics (as when plucking
a string on a guitar, for example).
• The lower the Damping, the more pronounced this effect.
If you open the filter completely (turn Damping up to max) the harmonic
content is static – the sound does not get softer when decaying.
210