9.0

Included Effect Plug-ins
Distortion Plug-ins
At the top of the plug-in panel, there are six buttons, arranged according to the position
of the corresponding elements in the signal chain. These buttons open different pages in
the display section of the plug-in panel: Pre-Effects, Amplifiers, Cabinets, Post-Effects,
Microphone Position, Master, and Configuration.
Below the display section, the selected amplifier is shown. The color and texture of the area
below the amplifier indicate the selected cabinet.
Pre/Post-Effects
On the Pre-Effects and Post-Effects pages, you can select up to six common guitar effects.
On both pages, the same effects are available, the only difference being the position in the
signal chain (before and after the amplifier). On each page, every effect can be used once.
Each effect features an On/Off button known from stompbox effects, as well as individual
parameters.
Wah Wah
Pedal – Controls the filter frequency sweep.
Volume
Pedal – Controls the level of the signal passing through the effect.
Compressor
Intensity – Sets the amount by which an input signal is being compressed.
Limiter
Threshold – Determines the maximum output level. Signal levels above the set
threshold are cut off.
Release – Sets the time after which the gain returns to the original level.
21