9.0

Included Effect Plug-ins
Distortion Plug-ins
Decimator
Controls the resulting bit-resolution. The lower the resolution, the higher the
distortion effect.
Mode
Allows you to select one of the four operating modes. In each mode, the plug-in
sounds differently. Modes I and III are nastier and noisier, while modes II and IV
are more subtle.
S&H
Sets the amount by which the audio samples are decimated. At the highest
setting, nearly all of the information describing the original audio signal is
eliminated, turning the signal into unrecognizable noise.
Delay
To open the Delay section, click the Delay button.
Time
If tempo sync is activated, this is where you specify the base note value for
tempo-syncing the effect (1/1 to 1/32, straight, triplet, or dotted).
If tempo sync is deactivated, the delay time can be set freely with the Time knob.
Sync
Activates/Deactivates tempo sync for the corresponding delay.
Duck
Determines how much the delay signal ducks when an audio signal is present.
Mix
Sets the level balance between the dry signal and the wet signal.
FBK
Determines the number of repeats for each delay.
Mode
If this option is activated, the delay signal is routed back into the distortion unit to
create a feedback with distortion.
NOTE
High FBK values and low Duck values in combination with activated Mode can lead to
unwanted noise.
Slider
Width
Sets the stereo width for the corresponding band.
19