9.0

MIDI Effects
StepDesigner
•
To remove a note from the pattern, click on it again.
NOTE
Each step can contain one note only – StepDesigner is monophonic.
RESULT
If you now start playback in your host application, the pattern plays as well, sending out MIDI
notes on the track’s MIDI output and channel (or, if you activated StepDesigner as a send
effect, on the MIDI output and channel selected for the send in the Inspector).
Adding Controller Curves
PROCEDURE
1. Open the Controller pop-up menu and select a controller.
The selection is displayed in the lower controller display.
2. Click in the controller display to draw events.
The MIDI controller events are sent out during playback along with the notes.
NOTE
If you drag a controller event bar all the way down, no controller value is sent out on
that step.
Setting Up the Controller Menu
You can specify which two controller types (filter cutoff, resonance, volume, etc.) should be
available on the Controller pop-up menu.
PROCEDURE
1. Click Setup.
2. Select the controllers that you want to have available in the Controller pop-up menu
and click OK.
This selection is global, that is, it applies to all patterns.
Adjusting the Step Length
•
To make notes shorter, select Gate on the Controller pop-up menu and lower the bars
in the controller display.
186