9.0

Included Effect Plug-ins
Distortion Plug-ins
Saturation
Determines the amount of saturation and the generation of overtones. This leads
to a small increase in input gain.
Saturation On/Off
Activates/Deactivates the saturation effect.
Dual Mode
Simulates the use of two machines.
Frequency Range Low/Hi
These parameters set the frequency range of the spectrum band to which the
tape effect is applied.
For example, to avoid the saturation of lower frequencies, set the Freq Low value
to 200 Hz or 300 Hz. To avoid the saturation of very high frequencies, set the Freq
Hi parameter to values below 10 kHz.
Tape Solo
Allows you to hear only the set frequency range including the tape simulation
effect. This helps you to determine the appropriate frequency range.
HF-Adjust
Sets the amount of high frequency content of the saturated signal.
HF-Adjust On/Off
Activates/Deactivates the HF-Adjust filter.
VU Input/Output
The buttons determine whether the VU meter shows the level of the input or of
the output signal. To set the input/output level, use the knob or enter a value in
the value field.
15