9.0

Included Effect Plug-ins
Spatial + Panner Plug-ins
Lo Level
Affects the decay time of the low frequencies. Normal room reverb decays
quicker in the high- and low-frequency range than in the mid-range. Lowering
the level percentage causes low frequencies to decay quicker. Values above 100 %
cause low frequencies to decay more slowly than the mid-range frequencies.
Mix
Sets the level balance between the dry signal and the wet signal. When using
RoomWorks SE inserted in an FX channel, you most likely want to set this to 100
%.
Spatial + Panner Plug-ins
Anymix Pro
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase
Pro
Nuendo NEK
Included with – – – – – X –
The Anymix Pro plug-in from IOSONO is a sophisticated surround panner and a powerful
upmix/downmix processor that converts any given audio material into output formats
ranging from mono to 8.1.
Input/Output Configuration
The input/output configuration of the plug-in can be selected from the In and Out pop-up
menus in the top left corner of the plug-in panel.
If Anymix Pro is used as an insert effect, the maximum input and output configuration cannot
exceed the track width of the current track.
If Anymix Pro is used as a panner, the maximum input configuration cannot exceed the track
width of the current track. The maximum output configuration cannot exceed the width of the
output bus that the track is routed to.
Channel Order
The plug-in uses the channel order of the host application unless the selected output
configuration differs from the track configuration.
NOTE
Choosing an output configuration that differs from the current track configuration results in
channel oddities.
124