9.0

Included Effect Plug-ins
Reverb Plug-ins
Damping
Lo Freq
Determines the frequency below which low-frequency damping occurs.
Hi Freq
Determines the frequency above which high-frequency damping occurs.
Lo Level
Affects the decay time of the low frequencies. Normal room reverb decays
quicker in the high- and low-frequency range than in the mid-range. Lowering
the level percentage causes low frequencies to decay quicker. Values above 100 %
cause low frequencies to decay more slowly than the mid-range frequencies.
Hi Level
Affects the decay time of the high frequencies. Normal room reverb decays
quicker in the high- and low-frequency range than in the mid-range. Lowering
the level percentage causes high frequencies to decay quicker. Values above 100
% cause high frequencies to decay more slowly than the mid-range frequencies.
Envelope
Amount
Determines how much the envelope attack and release controls affect the reverb
itself. Lower values have a more subtle effect while higher values lead to a more
drastic sound.
Attack
The envelope settings in RoomWorks control how the reverb follows the dynamics
of the input signal in a fashion similar to a noise gate or downward expander.
Attack determines how long it takes for the reverb to reach full volume after
a signal peak (in milliseconds). This is similar to a pre-delay, but the reverb is
ramping up instead of starting all at once.
Release
Determines how long after a signal peak the reverb can be heard before being cut
off, similar to a release time of a gate.
Output
Mix
Sets the level balance between the dry signal and the wet signal. If RoomWorks is
used as an insert effect for an FX channel, you most likely want to set this to 100
% or use the wet only button.
Wet only
This button deactivates the Mix parameter, setting the effect to 100 % wet or
affected signal. This button should normally be activated if RoomWorks is used as
a send effect for an FX channel or a group channel.
122