9.0

Included Effect Plug-ins
Reverb Plug-ins
NOTE
The impulse response is cut without any fading.
EQ Settings
In the Equalizer section, you can tune the sound of the reverb.
EQ curve
Shows the EQ curve. You can use the EQ parameters below the display to change
the EQ curve, or modify the curve manually by dragging the curve points.
Activate EQ
This button to the right of the EQ parameters activates the EQ for the effect plug-
in.
Low Shelf On
Activates the low shelf filter that boosts or attenuates frequencies below the
cutoff frequency by the specified amount.
Low Freq (20 to 500)
Sets the frequency of the low band.
Low Gain (-24 to +24)
Sets the amount of attenuation/boost for the low band.
Mid Peak On
Activates the mid peak filter that creates a peak or notch in the frequency
response.
Mid Freq (100 to 10000)
Sets the center frequency of the mid band.
Mid Gain(-12 to +12)
Sets the amount of attenuation/boost for the mid band.
115