4.0

22
The included effect plug-ins
Modulation plug-ins
This section contains descriptions of the plug-ins in the
“Modulation” category.
AutoPan
AutoPan automatically moves the track’s signal from left to
right and back again.
The parameters are as follows:
Chorus
Chorus works by doubling whatever is sent into it with a
slightly detuned version.
The parameters are as follows:
Parameter Description
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Rate This determines how quickly the signal moves back and
forth. If tempo sync is on, this is where you specify the
base note value for tempo syncing the flanger sweep (1/
1 to 1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob, without sync to tempo.
Width With this parameter you can adjust how far to the left and
right the signal will go.
Parameter Description
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Rate With this parameter you can change the speed of the
chorus effect. This determines how quickly the signal
moves back and forth. If tempo sync is on, this is where
you specify the base note value for tempo syncing the
flanger sweep (1/1 to 1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob, without sync to tempo.
Width With this parameter you can adjust how much the signal
is detuned.
Mix With this parameter you can set how much original signal
you hear versus the affected signal.