1.0

CUBASE LE Effects Parameters
30
Symphonic
The Symphonic plug-in combines a stereo enhancer, an auto-panner
synchronized to tempo and a chorus-type effect. For best results, ap-
ply the Symphonic effect to stereo signals.
The parameters are as follows:
Parameter Description
Mix Sets the level balance between the dry signal and the effect. If Sym-
phonic is used as a send effect, this should be set to maximum as you
can control the dry/effect balance with the send.
Tempo sync
on/off
The button below the Temp sync knob is used to switch tempo sync
on or off. The button is blue when tempo sync is on, and white when it
is off.
Tempo Sync
pop-up
If tempo sync is on, this is where you specify the base note value for
tempo syncing the auto-panning (1/1 - 1/32, straight, triplet or dot-
ted).
Tempo Sync
knob
This is the note value multiplier (x1 to x10), determining the timing of
the auto-panning.
Delay This determines the delay time and thus the character of the chorus
effect, if activated.
Depth This controls the depth of the chorus effect.
If you only want to use Symphonic as an auto-panner or a stereo en-
hancer, set this to 0%.
Rate This sets the modulation rate for the chorus effect, if activated.