1.0

Effects Parameters CUBASE LE
3
DoubleDelay
This effect provides two separate delays that can be either tempo
based or use freely specified delay time settings. Cubase LE automat-
ically provides the plug-in with the tempo currently used in the project.
The parameters are as follows:
Parameter Description
Mix Sets the level balance between the dry signal and the effect. If Double-
Delay is used as a send effect, this should be set to maximum (100%)
as you can control the dry/effect balance with the send.
Tempo sync
on/off
The buttons above the two Delay Time knobs are used to turn tempo
sync on or off for the respective delay. If set to off (the buttons are
white) the delay time can be set freely with the Delay Time knobs, with-
out sync to tempo.
Delay Time 1 This is where you specify the base note value for the delay if tempo
sync is on (1/1 - 1/32, straight, triplet or dotted). If tempo sync is off, it
sets the delay time in milliseconds.
Delay Time 2 As above.
Feedback This sets the number of repeats for both delays.
Tempo Sync 1 The note value multiplier (x1 to x10) for the first delay unit.
Tempo Sync 2 As above, but for the second delay unit.
Pan1 This sets the stereo position for the first delay.
Pan2 This sets the stereo position for the second delay.