1.0

CUBASE LE Effects Parameters
24
Phaser
The Phaser plug-in produces the classic “swooshing” sound that
characterizes phasing. It works by shifting the phase of the signal and
adding it back to the original signal, causing partial cancellation of the
frequency spectrum.
You can also change parameters in the graphic display window. This
works as follows:
• If tempo sync is on, you can set the base note value by clicking the
waveform and dragging left and right.
When tempo sync is off, this sets the Rate parameter.
Parameter Description
Mix Sets the level balance between the dry signal and the effect. If the
Phaser is used as a send effect, this should be set to maximum as you
can control the dry/effect balance with the send.
Tempo sync
on/off
The button above the Rate knob is used to switch tempo sync on or off.
The button is blue when tempo sync is on, and white when it is off.
Rate If tempo sync is on, this is where you specify the base note value for
tempo syncing the Phaser sweep (1/1 - 1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with the Rate knob,
without sync to tempo.
Feedback This sets the amount of feedback. A higher value produces a more pro-
nounced effect.
TMP Sync
knob
This is the note value multiplier (x1 to x10) for the Phaser sweep when
tempo sync is used.
Stereo Basis This sets the stereo width of the effect. 0% is mono, 50% original stereo,
and 100% maximum stereo enhancement.