1.0

Effects Parameters CUBASE LE
21
Flanger
Flanger is a classic flanger effect with stereo enhancement. Parameters
are as follows:
Parameter Description
Mix Sets the level balance between the dry signal and the effect. If the
Flanger is used as a send effect, this should be set to maximum as you
can control the dry/effect balance with the send.
Tempo sync
on/off
The button above the Rate knob is used to switch tempo sync on or off.
The button is blue when tempo sync is on, and white when it is off.
Rate If tempo sync is on, this is where you specify the base note value for
tempo syncing the flanger sweep (1/1 - 1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with the Rate knob,
without sync to tempo.
Tempo Sync
knob
This is the note value multiplier (x1 to x10) for the flanger sweep when
tempo sync is used.
Shape Sync
knob
This changes the shape of the modulating waveform, altering the char-
acter of the flanger sweep.
Feedback This determines the character of the flange effect. Higher settings pro-
duce a more “metallic” sounding sweep.
Depth This sets the depth of the modulation sweep.
Delay This parameter affects the frequency range of the modulation sweep, by
adjusting the initial delay time.
Stereo Basis This sets the stereo width of the effect. 0% is mono, 50% original ste-
reo, and 100% maximum stereo enhancement.