1.0

Effects Parameters CUBASE LE
11
Trigger Frequency Range
Autogate has a feature that allows the gate to be triggered only by sig-
nals within a specified frequency range. This is a most useful feature
because it lets you filter out parts of the signal that might otherwise
trigger the gate in places you don’t want it to, thus allowing more con-
trol over the gate function. The Trigger Frequency Range function is
set using the control in the upper part of the Autogate panel, and the
buttons located below it.
The basic operation of the Trigger Frequency Range function is as
follows:
1. While playing back audio, click the “Listen” button.
You will now monitor the audio signal, and the gate will be bypassed.
2. While listening, drag the two handles in the Trigger Frequency Range
window to set the frequency range you wish to use to trigger the gate.
You will hear the audio being filtered as you move the handles.
• Dragging the left handle to the right will progressively cut frequencies starting
from the low end of the frequency spectrum.
• Dragging the right handle to the left will progressively cut frequencies starting
from the high end of the frequency spectrum.
3. After setting the frequency range, click the “On” button.
Autogate will now use the selected frequency range as the trigger input.
4. To disable the Trigger Frequency Range function, click the “Off” button.
Autogate will now use the unfiltered audio signal as the trigger input.
The frequency range between the two handles will
be used to trigger the gate.