8.0

JLCooper MCS-3000
Transport Control
66
• To select a parameter group, press the corresponding PAGE button above
the LCD display.
• To set a parameter, rotate the corresponding encoder below the LCD display.
Panning
You can set the left-right panning for the selected channel with the leftmost encoder
on PAGE 1 or on PAGE 2.
Sends
You can set the level for the send slots 1 to 4 of the selected channel on PAGE 1.
You can set the level for the send slots 5 to 8 of the selected channel on PAGE 2.
Equalizer
You can activate/deactivate the four equalizer bands, and set the equalizer
parameters Frequency, Gain, and Q-Factor of the selected channel on PAGE 3,
PAGE 4, PAGE 5, and PAGE 6.
Transport Control
This section describes how to control the main transport functions of JLCooper
MCS-3000.
The buttons for play, stop, record, rewind, and fast forward of JLCooper MCS-3000
control the equivalent functionality in the DAW.
To move back or forward with a higher speed, hold down SHIFT and press the
rewind or the fast forward button.
The transport wheel of JLCooper MCS-3000 allows you to move the position of the
project cursor in your DAW. The wheel provides a jog function and a shuttle
function.
Working with Markers
You can create and locate markers in your project with the keypad in the transport
section of JLCooper MCS-3000.
• To create a marker at the current cursor position, press the SET LOCATE
button, then type in a marker ID with the keypad, then press the ENTER
button.
• To move the cursor to a particular marker, press the LOCATE button, then
type in a marker ID with the keypad, then press the ENTER button.