8.0

64
JLCooper MCS-3000
Setting Up JLCooper MCS-3000
This section describes how to set up JLCooper MCS-3000 in your DAW
application.
You must add each new remote control device in the Device Setup dialog of
Cubase or Nuendo.
PROCEDURE
1. Connect JLCooper MCS-3000 to your computer.
2. Turn on JLCooper MCS-3000.
3. Start Cubase or Nuendo.
4. Select Devices > Device Setup > Add Device.
5. In the Device Setup dialog, click + and select JLCooper MCS-3000.
6. Select the MIDI Input for JLCooper MCS-3000.
7. Select the MIDI Output for JLCooper MCS-3000.
8. Select MIDI Port Setup in the list on the left.
9. On the table on the right, locate the MIDI input to which you have connected
the remote device.
10. Deactivate the checkbox in the In ‘All MIDI Inputs’ column for that input.
This avoids accidentally recording the data from the remote control device when All
MIDI Inputs is selected as input for a MIDI track.
11. Click OK to close the Device Setup dialog.
Mixer Functions
This section describes how to work with the faders, how to mute and solo channels,
how to enable tracks for recording, and how to assign and select channels.
Faders
The faders in the channel set are used for hands-on level control and mixing, and
allow adjustments of the corresponding channel levels in your application.