8.0

Mackie HUI
Transport Control
60
SHIFT/ADD + QUICK PUNCH
Activates/Deactivates Auto Punch Out
Transport Wheel
The transport wheel below the main transport bar allows you to move the position
of the project cursor in your DAW. The wheel also provides a jog function and a
shuttle function.
• To move the cursor position in the Project window, rotate the transport wheel
in the standard mode.
• To activate/deactivate the jog mode, press the SCRUB button to the right of
the Transport wheel. If the jog mode is activated, the SCRUB button LED
lights up.
• To activate/deactivate the shuttle mode, press the SHUTTLE button to the
right of the Transport wheel. If the shuttle mode is activated, the SHUTTLE
button LED lights up.
Time Display Modes
The LEDs left of the time code display indicate the current display mode. The
following applies:
TIME CODE
Frame-based timecode
FEET
Feet + Frames
BARS
Bars + Beats
No LED lit
Samples
Direct Cursor Positioning
The LOCATE/NUMERICS section allows you to directly set the cursor position.
• To set a new value, use the buttons 0 to 9.
• To move the cursor to the new position, press the ENTER button.
• To delete the last character, press the CLR button.
• To delete the new value, hold down SHIFT/ADD and press the CLR button.
• To move the cursor forward by the amount of the time that is set with the new
value, press the + button.