8.0

Mackie HUI
VST Parameter Settings
57
Generally, routing destinations are assigned exclusively. Therefore only one output
can be active at the same time. However, direct routing offers a summing mode that
allows you to feed your signals to several outputs at a time.
The following applies:
• To access the direct routing settings, hold down SHIFT/ADD and press the
F3 button.
• On Page 01, you can activate/deactivate the direct routing slots 1 to 4.
•On Page 02, you can activate/deactivate the direct routing slots 5 to 8.
•On Page 03, you can activate/deactivate the direct routing summing mode.
VST Parameter Settings
This section describes how to remote-control the settings for equalizer, insert
effects, and VST instruments with Mackie HUI.
For all VST parameter settings in the DSP/EDIT ASSIGN section, the following
applies:
• To scroll through the pages of a parameter group, rotate the SCROLL
encoder.
• To move to the next page within a parameter group, press the COMPARE
button.
• To move directly to last available page within a parameter group, hold down
SHIFT/ADD and press the COMPARE button.
• To move to the previous page within a parameter group, press the BYPASS
button.
• To move directly to the first available page within a parameter group, hold
down SHIFT/ADD and press the BYPASS button.
• To switch the device display between parameter names and parameter
values, press the INSERT/PARAM button.
• To set a parameter, rotate the corresponding encoder in the DSP
EDIT/ASSIGN section.
Equalizer
You can activate/deactivate an equalizer band, edit the equalizer parameters
Frequency, Gain, and Q-Factor, and bypass the equalizer for the selected channel.
The following applies:
• To access the equalizer settings, press the F1 button.
•On Page 01 to Page 04, you can set the parameters of band 1 to 4.
• To bypass the equalizer, press one of the SELECT buttons in the DSP
EDIT/ASSIGN section.