8.0

Mackie HUI
Mixer Parameter Settings
56
• To switch between left-right and the front-rear panning, press the PAN button
again. This setting is reflected in the SELECT ASSIGN display.
• To set the panning for a particular channel, rotate the corresponding
PAN/SEND encoder.
Sends
For audio channels, you can control the sends for the selected channel and for the
current channel set.
You can control the sends for the selected audio channel in the DSP/
EDIT/ASSIGN section. The following applies:
• To access the send settings for the selected channel, press the F2 button.
•On Page 01 to Page 08, you can activate/deactivate slots, set the level, and
switch between pre-fader and post-fader, for the send slots 1 to 8 of the
selected channel.
You can also directly control the sends of all currently assigned audio channels in
the ASSIGN section. The following applies:
• To access the settings for send 1 to send 4, press the SEND A to SEND D
buttons in the ASSIGN section. The SELECT-ASSIGN display reflects this
setting.
• To access the settings for send 5 to send 8, repeatedly press the SEND E
button in the ASSIGN section. The SELECT-ASSIGN display reflects this
setting.
• To activate/deactivate a send, press the corresponding V-SEL button in the
channel set section.
• To set the level of a send, rotate the corresponding PAN/SEND encoder in
the channel set section.
• To switch a send between pre-fader and post-fader, rotate the corresponding
PAN/SEND encoder.
Routing
You can control the routing settings for the selected channel. The following applies:
• To access the routing settings, press the F3 button.
•On Page 01, you can set the output bus, the input bus, and the input gain,
and activate/deactivate monitoring.
•On Page 02, you can set the input phase.
Direct Routing (Nuendo only)
Mackie HUI provides you with access to the direct routing for audio tracks,
instrument tracks, FX channel tracks, groups, and output busses.