8.0

5
Mackie MCU Pro
This chapter only describes the specific remote-control functions of
Mackie
MCU Pro for the Steinberg DAW applications Cubase and Nuendo. For
further information regarding the functionality of Mackie
MCU Pro, refer to the
documentation that is provided by the manufacturer. For further information
regarding the software functionality, refer to the documentation of Cubase and
Nuendo.
NOTE
This chapter also applies to older versions of Mackie MCU Pro, the Logic Control,
the Mackie Control, and the Mackie Control Universal.
The following section describes the setup settings for Mackie MCU Pro remote
controllers in Cubase and Nuendo, the use of Mackie
MCU XT Pro extender units,
and the Steinberg-specific layout for Mackie
MCU Pro.
Setting Up Mackie MCU Pro
This section describes how to set up Mackie MCU Pro in your DAW application.
You must add each new remote control device in the Device Setup dialog of
Cubase or Nuendo.
PROCEDURE
1. Connect Mackie MCU Pro to your computer.
2. Turn on Mackie MCU Pro.
3. Start Cubase or Nuendo.
4. Select Devices > Device Setup > Add Device.
5. In the Device Setup dialog, click + and select Mackie Control.
6. Select the MIDI Input for the Mackie Control device.
7. Select the MIDI Output for the Mackie Control device.
8. Select MIDI Port Setup in the list on the left.
9. On the table on the right, locate the MIDI input to which you have connected
the remote device.