8.0

Mackie MCU Pro
Mixer Parameter Settings
15
Level Meters
When the display shows parameter settings, you can activate level meters for each
channel in the display.
• To activate/deactivate the level meters in the display, hold down SHIFT and
press the SMPTE/BEATS button.
Mixer Parameter Settings
You can remote-control the several mixer parameter settings of your project with
Mackie
MCU Pro.
Mackie MCU Pro allows you to remote-control the following mixer parameter
groups:
•Panning
•Sends
•Cue sends
•Routing
• Direct routing (Nuendo only)
To show the mixer parameter settings in the device display and set the values,
proceed as follows:
1) To select a parameter group, press the corresponding parameter group
button.
2) To move to the next or previous Page within a parameter group, press the
right or left CHANNEL button in the FADER BANKS section.