6.0

7
The supported remote control devices
ROTARY: S2
• equaliz button: Fader Set mode Send 5
• dynmics button: Fader Set mode Send 6
• delay button: Fader Set mode Send 7
• special button: Fader Set mode Send 8
• Use the Bank Up button in the View section for page up.
Hold down Shift and press the Bank Up button to jump to the last page.
• Use the Bank Down button in the View section for page
down.
Hold down Shift and press the Bank Down button to jump to the first
page.
• Press the Rotary dial to switch the display of names of
the available parameters or the page name on or off.
Fader Set mode Panning:
• Page 1 – panning left/right
• Page 2 – panning front/rear
• Buttons below dials: monitor
Fader Set mode Routing:
• Page 1 – Output Bus
•Page 2 – Monitor
•Page 3 – Input Bus
•Page 4 – Input Gain
• Page 5 – Input Phase
• Buttons below dials: monitor
Selected Channel mode Panning:
• Page 1 – panning left/right, panning front/rear
• Buttons below dials: monitor
Selected Channel mode Routing:
• Page 1 – Output Bus, Monitor, Input Bus, Input Gain, Input
Phase
• Buttons below dials: monitor
Fader Set mode EQ1 to EQ4 (e. g. EQ1):
• Page 01 – EQ Low Gain
• Page 02 – EQ Low Frequency
• Page 03 – EQ Low Q
• Page 04 – EQ Low Enable
•Page 05 – Bypass EQs
• Buttons below dials: bypass EQs
Fader Set mode Send1 to Send8 (e. g. Send1):
• Page 01 – Send1 Level
• Page 02 – Send1 Enable
• Page 03 – Send1 Pre/Post
• Page 04 – Send1 Bus
• Page 05 – Bypass Sends
• Buttons below dials: bypass sends
F2 button: Selected Channel mode EQ:
• Page 1 – Gain, Frequency, Q and Enable for the lo band,
Gain, Frequency, Q and Enable for the lo mid band
• Page 2 – Gain, Frequency, Q and Enable for the hi mid band,
Gain, Frequency, Q and Enable for the hi band
• Buttons below dials: bypass EQs
Holding down Shift and pressing the F2 button gives you
a variation of Selected Channel mode EQ:
• Page 1 – Gain and Frequency for all bands
• Page 2 – Q and Enable for all bands
• Buttons below dials: bypass EQs
F3 button: Selected Channel mode Sends
• Page 1 – Level, Enable, Pre/Post and Bus for Send 1 and
Send 2
• Page 2 – Level, Enable, Pre/Post and Bus for Send 3 and
Send 4
• Page 3 – Level, Enable, Pre/Post and Bus for Send 5 and
Send 6
• Page 4 – Level, Enable, Pre/Post and Bus for Send 7 and
Send 8
• Buttons below dials: bypass sends
Holding down Shift and pressing the F3 button gives you
a variation of Selected Channel mode Sends:
• Page 1 – Level for Send 1 to Send 8
• Page 2 – Enable for Send 1 to Send 8
• Page 3 – Pre/Post for Send 1 to Send 8
• Page 4 – Bus for Send 1 to Send 8
• Buttons below dials: bypass sends
For a description of the functionalities for the F4 button:
Selected Channel mode Inserts, Next button: Global
mode Send Effects, Last button: Global mode Master Ef
-
fects, and Enter button: Global mode Instruments, see the
chapter
“Mackie Control” on page 18.