6.0
Table Of Contents
- Table of Contents
- The supported remote control devices
- Introduction
- Apple Remote (Macintosh only)
- CM Automation Motor Mix
- Steinberg Houston
- JL Cooper CS-10
- JL Cooper MCS-3000
- Mackie Control
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland MCR-8
- Tascam US-428
- Gallery Software ADRStudio (Nuendo only)
- WK-Audio ID (Nuendo only)
- Yamaha 01V
- Yamaha DM2000/DM 2000v2
- Yamaha DM1000v2
- Yamaha 01v96v2
- Yamaha 02r96v2
- Yamaha 01x
- Mackie Control
32
Mackie Control
• Press the Project button to bring the current Project
window to the front.
• Press the Mixer button to open or close the Mixer win-
dow.
• Press the Motors button to switch on or off the faders’
motors – see “Using the faders” on page 21.
• Press the Solo Defeat button to disable Solo for all
channels.
• Hold down Shift and press the Solo Defeat button to
disable Mute for all channels.
In the top right corner of Mackie Control, next to the dis-
play, you will find an LED labeled Rude Solo. This LED
lights up as soon as any channel has been soloed.
The Rude Solo LED
Function keys
You can use the function keys F1 to F8 and function key
combinations with the Shift button to access functions in
your application. Refer to the Operation Manual for infor
-
mation about how to assign program functions to remote
controller function keys.
On the rear panel of Mackie Control you will find two input
jacks for foot pedals, labeled User Switch A and B.
The switches and inputs on the rear panel of Mackie Control
The procedure for assigning functions to these foot ped-
als is the same as for the function keys (see above).
Cursor keys
Pressing the cursor keys located to the left of the jog
wheel is the same as pressing the arrow keys on your
computer keyboard.
Showing level meters in the parameter display
You can show level meters for each channel in the para-
meter display. This is done by pressing Shift and the
SMPTE/Beats button. Pressing the same buttons again
reverts the display back to parameter mode.