6.0
Table Of Contents
- Table of Contents
- The supported remote control devices
- Introduction
- Apple Remote (Macintosh only)
- CM Automation Motor Mix
- Steinberg Houston
- JL Cooper CS-10
- JL Cooper MCS-3000
- Mackie Control
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland MCR-8
- Tascam US-428
- Gallery Software ADRStudio (Nuendo only)
- WK-Audio ID (Nuendo only)
- Yamaha 01V
- Yamaha DM2000/DM 2000v2
- Yamaha DM1000v2
- Yamaha 01v96v2
- Yamaha 02r96v2
- Yamaha 01x
- Mackie Control
30
Mackie Control
Transport control
This section describes how to control playback, record-
ing, positioning and the time display in your application
from Mackie Control.
The transport controls of Mackie Control are located in
the lower right corner of the panel:
• Note that pressing Shift while pressing Rewind or Fast
Forward will move the project cursor to the beginning or
the end of the project.
About the jog wheel
The jog wheel will only move the project cursor position in
your program.
If you press the Scrub button above the jog wheel, the jog
function in your program will be used, i.e. you will hear
playback.
Working with markers
You can use Mackie Control to move directly to particular
positions defined in your project with the aid of markers.
Also, you can place such a marker at the current position in
the project. The most common use for this is probably to
move to the L and R markers – the left and right locators.
Fast Forward
Play
Stop RecordRewind
Jog Wheel
Cursor keys, see “Cur-
sor keys” on page 32.