6.0
Table Of Contents
- Table of Contents
- The supported remote control devices
- Introduction
- Apple Remote (Macintosh only)
- CM Automation Motor Mix
- Steinberg Houston
- JL Cooper CS-10
- JL Cooper MCS-3000
- Mackie Control
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland MCR-8
- Tascam US-428
- Gallery Software ADRStudio (Nuendo only)
- WK-Audio ID (Nuendo only)
- Yamaha 01V
- Yamaha DM2000/DM 2000v2
- Yamaha DM1000v2
- Yamaha 01v96v2
- Yamaha 02r96v2
- Yamaha 01x
- Mackie Control
26
Mackie Control
Selected Channel: FX Send
Accessing the FX Send (auxiliary) controls for the currently
selected channel is done by pressing the DYN button in
the Assignment section. Pressing Shift+ DYN will step
through Fader Set mode “FX Send 1” to “FX Send 8”.
Please select a channel by pressing one of the Select but-
tons above the faders.
The controls for the sends are divided into 4 pages:
• Page 1
Send Levels for each of the 8 FX Sends.
• Page 2
Enable switches for each of the 8 FX Sends.
• Page 3
Switches to change between pre/post fader mode.
• Page 4
Controls to choose the destination of the FX send signal.
!
The Bus destinations control whether the FX send
signal is sent directly to the internal effects, to the
Group channels or to a physical bus output (if your
sound card has additional outputs).