6.0

25
Mackie Control
About the symbols
On the following pages, all the different parameter groups
are described. The parameter groups are divided accord-
ing to the three modes, Selected Channel, Fader Set and
Global.
For quick navigation in this chapter, an icon at the top of
each page shows to which mode it belongs:
This icon indicates the “vertical” Selected Channel mode.
This icon indicates the “horizontal” Fader Set mode.
This icon indicates Global mode.
When a group of parameters has more than one page of
parameters in the Mackie Control display, this is indicated
by the following symbol:
This corresponds to the I/O and Sends buttons in the
Assignment section of Mackie Control.
For example, in the picture below, you would use the I/O
and Sends buttons to switch between the “Level” and the
“Enable” parameter pages:
Selected Channel: EQ
Accessing the EQ controls for the currently selected
channel is achieved by pressing the EQ button in the As-
signment section. If you press Shift + EQ one band per
page will be shown for the selected channel.
Please select a channel by pressing one of the Select but-
tons above the faders.
The controls for the equalizers are divided into 2 pages:
• Page 1
Frequency and Gain pairs for the four bands.
• Page 2
Enable and Q controls for the four bands.