6.0

11
Menu Reference
Advanced
The Advanced submenu contains the following items:
Events to Part
This allows you to create a part from selected audio
events.
Dissolve Part
This menu item dissolves a selected audio part and makes
any audio events it contains appear as independent ob
-
jects on the track.
Snap Point to Cursor (Cubase Elements only)
This allows you to set the snap point to the current cursor
position.
Bounce Selection
This allows you to create either a new clip or a new audio
file from a selection.
Find Selected in Pool
This can be used to quickly find the clips in the Pool for
events selected in the Project window. When this menu
item is selected, the Pool opens with the corresponding
clip(s) highlighted.
Update Origin (Cubase Elements only)
The original start position where a clip was recorded in the
project is shown in the Pool’s “Origin Time” column. As this
value can be used as a basis for the “Insert into Project”
Media menu item (and other functions), you can change it if
desired. This can be done by selecting the corresponding
clip in the Pool, moving the project cursor to the new posi-
tion and selecting this menu item.
Crossfade
This allows you to create a crossfade between two se-
lected consecutive audio events.
• If the two events overlap, the crossfade will be applied
to the overlapping area.
• If they do not overlap (but their respective audio clips
do), the events are resized and a crossfade is applied in
the overlapping range.
Remove Fades
This will remove any fades or crossfades from a selected
event.
Open Fade Editor(s)
This opens the Fade dialog for a selected event. Note that
this will open two dialogs if the event has both fade-in and
fade-out curves.
Option Description
Detect Silence The Detect Silence function searches for silent sections
in an event, and either splits the event, removing the silent
parts from the project, or creates regions corresponding
to the non-silent sections.
Event or
Range as
Region
This function is available when one or several audio
events are selected or a selection range has been made
encompassing one or several audio events. It creates a
region in the corresponding clip, according to the follow
-
ing rules:
• If no selection range or hitpoints exist, the start and end
position of the region will be determined by the start and
end position of the event within the clip.
• If a selection range exists in the event, this will be used.
• If hitpoints exist in the event, regions will be created be-
tween each hitpoint.
Events from
Regions
This function is available if you have selected an audio
event whose clip contains regions within the boundaries
of the event. The function will remove the original event
and replace it with event(s) positioned and sized accord
-
ing to the region(s).
Set Tempo
from Event
Adjusts the project tempo to the tempo detected in the
edited loop.
Set Definition
from Tempo…
Opens the Set Definition From Tempo dialog, which you
can use to save the tempo information from the tempo
track in the selected audio clips.
Close Gaps
(Time Stretch)
Applies time stretch to close the gaps between slices of
a sliced audio event (typically when the project tempo is
lower than the loop tempo).
Close Gaps
(Crossfade)
Closes the gaps between slices of a sliced audio event
and applies crossfades.
Stretch to
Project Tempo
Stretches the selected event(s) to fit the project tempo.
Requires that hitpoints have been calculated for the
event(s).
Delete
Overlaps
Used when recording audio in Cycle Recording mode.
After editing the takes (composing a “perfect take” for ex
-
ample), you can select Delete Overlaps to remove all
overlapped material.