8.0

Remote controlling Cubase
The Remote Control Editor (Cubase Elements only)
400
Increasing Stepwise (cycle)
Pressing the switch steps through the available settings, starting over with the
mi
nimum value when the maximum is reached.
Decreasing Stepwise (cycle)
Pressing the switch steps through the available settings in re
verse order,
starting over with the maximum value when the minimum is reached.
Smart Switch
This changes between two states every time you press
the switch, like an On/Off
button. Furthermore, if you keep the switch pressed, you enter Momentary mode,
that is, the corresponding function stays active for as long as the button is pressed.
Invert Control Value
This inverts the control state/value.
Hide Control When Inactive
Hides plug-in parameters when they are inactive or disabled.
Assigning Parameters to Controls
PROCEDURE
1. Click the L button on the toolbar to activate Learn mode for the editor.
2. In the editor, select the control that you want to assign to a plug-in parameter.
A colored frame around a control shows that this control has the Learn focus.
3. Click on a parameter on the plug-in panel.
This assigns that parameter to the control.
You can also double-click on a control in the edit
or to open the list of available plug-in
parameters, and click a parameter to assign it to the control.
4. Click on another control to set the Learn focus to that control and assign a
parameter to it.
5. Press [Esc] to end Learn mode.
Removing the Parameter assignment
• To remove the parameter assignment for a cell, activate Learn mode, select
the cell, and press [Delete] or [Backspace].
• To remove all assignments, click the “Remove All Assignments” button.