5.0

18
Setting up your system
About monitoring
In Cubase AI, monitoring means listening to the input sig-
nal while preparing to record or while recording. There are
three ways to monitor:
External monitoring
External monitoring (listening to the input signal before it
goes into Cubase AI) requires an external mixer for mixing
the audio playback with the input signal. This can be a
classic mixing desk or a mixer application for your audio
hardware, if this has a mode in which the input audio is
sent back out again (usually called “Thru”, “Direct Thru” or
similar).
Via Cubase AI
In this case, the audio passes from the input into Cubase
AI, possibly through Cubase AI effects and EQ and then
back to the output. You control monitoring via settings in
Cubase AI.
This allows you to control the monitoring level from Cu-
base AI and add effects to the monitored signal only.
ASIO Direct Monitoring
If your audio hardware is ASIO 2.0 compatible, it may sup-
port ASIO Direct Monitoring (this feature may also be avail-
able for audio hardware with Mac OS X drivers). In this
mode, the actual monitoring is done in the audio hardware,
by sending the input signal back out again. However, moni-
toring is controlled from Cubase AI. This means that the au-
dio hardware’s direct monitoring feature can be turned on
or off automatically by Cubase AI.
Monitoring is described in detail in the chapter “Record-
ing” in the Operation Manual. However, when setting up,
there’s one thing to note:
• If you want to use the external monitoring via your audio
hardware, make sure the corresponding functions are ac-
tivated in the card’s mixer application.
Ö If you are using RME Audio Hammerfall DSP audio
hardware, make sure that the pan law is set to -3dB in the
card’s preferences.
Setting up MIDI
This section describes how to connect and set up MIDI
equipment. If you have no MIDI equipment, you can skip
this section. Note that this is only an example – you might
need or want to hook things up differently!
Connecting the MIDI equipment
In this example we assume that you have a MIDI keyboard
and an external MIDI sound module. The keyboard is used
both for feeding the computer with MIDI messages for re-
cording and for playing back MIDI tracks. The sound mod-
ule is used for playback only. Using Cubase AI’s MIDI Thru
feature (described later) you will be able to hear the cor-
rect sound from the sound module while playing the key-
board or recording.
A typical MIDI Setup
If you want to use even more instruments for playback, sim-
ply connect MIDI Thru on the sound module to MIDI In on
the next instrument, and so on. In this hook-up, you will al-
ways play the first keyboard when recording. But you can
still use all your devices for providing sounds on playback.
!!
Make sure that all equipment is turned off before
making any connections!
!!
If you plan to use more than three sound sources, we
recommend that you either use an interface with
more than one output, or a separate MIDI Thru box
instead of the Thru jacks on each unit.