5.0
Table Of Contents
- Table of Contents
- The supported remote control devices
- Introduction
- Apple Remote (Macintosh only)
- CM Automation Motor Mix
- Steinberg Houston
- JL Cooper CS-10
- JL Cooper MCS-3000
- Mackie Control
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland MCR-8
- Tascam US-428
- Gallery Software ADRStudio
- WK-Audio ID
- Yamaha 01V
- Yamaha DM2000/DM 2000v2
- Yamaha DM1000v2
- Yamaha 01v96v2
- Yamaha 02r96v2
- Yamaha 01x
- Mackie Control
- Index
26
Mackie Control
Selected Channel: EQ
Accessing the EQ controls for the currently selected
channel is achieved by pressing the EQ button in the As-
signment section. If you press Shift + EQ one band per
page will be shown for the selected channel.
Please select a channel by pressing one of the Select but-
tons above the faders.
The controls for the equalizers are divided into 2 pages:
• Page 1
Frequency and Gain pairs for the four bands.
• Page 2
Enable and Q controls for the four bands.
Selected Channel: FX Send
Accessing the FX Send (auxiliary) controls for the currently
selected channel is done by pressing the DYN button in the
Assignment section. Pressing Shift+ DYN will step through
Fader Set mode “FX Send 1” to “FX Send 8”.
Please select a channel by pressing one of the Select but-
tons above the faders.
The controls for the sends are divided into 4 pages:
• Page 1
Send Levels for each of the 8 FX Sends.
• Page 2
Enable switches for each of the 8 FX Sends.
• Page 3
Switches to change between pre/post fader mode.