6.0

6
The included effect plug-ins
Introduction
This chapter contains descriptions of the included plug-in
effects and their parameters.
In Cubase, the plug-in effects are arranged in a number of
different categories. This chapter is arranged in the same
fashion, with the plug-ins listed in separate sections for
each effect category.
Ö Most of the included effects are compatible with
VST3, this is indicated by an icon in front of the name of
the plug-in as displayed in plug-in selection menus (for
further information, see the chapter “Audio effects” in the
Operation Manual).
Delay plug-ins
This section contains descriptions of the plug-ins in the
“Delay” category.
MonoDelay
This is a mono delay effect that can either be tempo-
based or use freely specified delay time settings.
The following parameters are available:
PingPongDelay
(Cubase Elements only)
This is a stereo delay effect that alternates each delay re-
peat between the left and right channels. The effect can
either be tempo-based or use freely specified delay time
settings.
The following parameters are available:
Parameter Description
Delay If tempo sync is on, this is where you specify the base
note value for the delay (1/1–1/32, straight, triplet, or
dotted).
If tempo sync is off, the delay time can be set freely in
milliseconds.
Sync button The button below the Delay knob is used to switch tempo
sync on or off.
Feedback Sets the number of repeats for the delay.
Filter Lo This filter affects the feedback loop of the effect signal
and allows you to roll off low frequencies from 10
Hz up to
800
Hz. The button below the knob activates/deactivates
the filter.
Filter Hi This filter affects the feedback loop of the effect signal
and allows you to roll off high frequencies from 20
kHz
down to 1.2
kHz. The button below the knob activates/
deactivates the filter.
Mix Sets the level balance between the dry and the wet sig-
nal. If MonoDelay is used as a send effect, set this to the
maximum value as you can control the dry/effect balance
with the send.
Parameter Description
Delay If tempo sync is on, this is where you specify the base
note value for the delay (1/1–1/32, straight, triplet, or
dotted).
If tempo sync is off, the delay time can be set freely in
milliseconds.
Sync button The button below the Delay Time knob is used to switch
tempo sync on or off.
Feedback Sets the number of repeats for the delay.
Filter Lo This filter affects the feedback loop and allows you to roll
off low frequencies up to 800
Hz. The button below the
knob activates/deactivates the filter.
Filter Hi This filter affects the feedback loop and allows you to roll
off high frequencies from 20
kHz down to 1.2 kHz. The
button below the knob activates/deactivates the filter.
Spatial Sets the stereo width for the left/right repeats. Turn clock-
wise for a more pronounced stereo “ping-pong” effect.
Mix Sets the level balance between the dry and the wet sig-
nal. If PingPongDelay is used as a send effect, set this to
the maximum value as you can control the dry/effect bal
-
ance with the send.
Parameter Description