6.0

15
The included effect plug-ins
Chorus
This is a single-stage chorus effect. It works by doubling
whatever is sent into it with a slightly detuned version.
The following parameters are available:
Flanger
Flanger is a classic flanger effect with added stereo
enhancement.
The following parameters are available:
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the chorus sweep (1/1 to
1/32, straight, triplet, or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob.
Sync button The button below the Rate knob is used to switch tempo
sync on or off.
Width Determines the depth of the chorus effect. Higher set-
tings produce a more pronounced effect.
Waveform
Shape selector
Allows you to select the modulation waveform, altering
the character of the chorus sweep. A sine and a triangle
waveform are available.
Spatial Sets the stereo width of the effect. Turn clockwise for a
wider stereo effect.
Mix Sets the level balance between the dry and the wet sig-
nal. If Chorus is used as a send effect, set this to the max-
imum value as you can control the dry/effect balance with
the send.
Delay Affects the frequency range of the modulation sweep by
adjusting the initial delay time.
Filter Lo/Hi Allow you to roll off low and high frequencies of the effect
signal.
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the flanger sweep (1/1 to
1/32, straight, triplet, or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob.
Sync button The button below the Rate knob is used to switch tempo
sync on or off.
Range Lo/Hi Set the frequency boundaries for the flanger sweep.
Feedback Determines the character of the flanger effect. Higher
settings produce a more “metallic” sounding sweep.
Spatial Sets the stereo width of the effect. Turn clockwise for a
wider stereo effect.
Mix Sets the level balance between the dry and the wet sig-
nal. If Flanger is used as a send effect, set this to the max-
imum value as you can control the dry/effect balance with
the send.
Waveform
Shape selector
Allows you to select the modulation waveform, altering
the character of the flanger sweep. A sine and a triangle
waveform are available.
Delay Affects the frequency range of the modulation sweep by
adjusting the initial delay time.
Manual knob Allows you to change the sweep position manually when
the Manual button is deactivated. The value range is from
0 to 100.
Manual button Use this button to activate/deactivate the Manual func-
tion. If activated, the flanger sweep is static, i. e. no mod-
ulation takes place.
Filter Lo/Hi Allow you to roll off low and high frequencies of the effect
signal.