6.0

13
The included effect plug-ins
ToneBooster (not in Cubase LE)
ToneBooster is a filter that allows you to raise the gain in a
selected frequency range. It is particularly useful when
inserted before AmpSimulator in the plug-in chain (see
“AmpSimulator” on page 7), greatly enhancing the tonal
varieties available.
The following parameters are available:
WahWah (not in Cubase LE)
WahWah is a variable slope band-pass filter that can be
auto-controlled via MIDI modeling the well-known analog
pedal effect (see below). You can independently specify
the frequency, width and the gain for the Lo and Hi Pedal
positions. The crossover point between the Lo and Hi
Pedal positions lies at 50.
The following parameters are available:
MIDI control
For realtime MIDI control of the Pedal parameter, MIDI
must be directed to the WahWah plug-in.
• Whenever WahWah has been added as an insert effect
(for an audio track or an FX channel), it is available on the
Output Routing pop-up menu for MIDI tracks.
If WahWah is selected on the Output Routing menu, MIDI data is di-
rected to the plug-in from the selected track.
Mastering plug-ins
This section contains descriptions of the plug-ins in the
“Mastering” category.
UV22HR (Cubase Elements only)
The UV22HR is a dithering plug-in, based on an advanced
algorithm developed by Apogee. For an introduction to the
concept of dithering, see the chapter “Audio effects” in
the Operation Manual.
Parameter Description
Tone Sets the center filter frequency.
Gain Allows you to adjust the gain of the selected frequency
range by up to 24
dB.
Width Sets the resonance of the filter.
Mode
selector
Sets the basic operational mode of the filter; Peak or Band
Mode.
Parameter Description
Pedal Controls the filter frequency sweep.
Pedal Control
(MIDI) pop-up
menu
Allows you to choose the MIDI controller that is used to
control the plug-in. Set this to “Automation” if you do not
want to use MIDI realtime control.
Freq Lo/Hi Set the frequency of the filter for the Lo and Hi Pedal
positions.
Width Lo/Hi Set the width (resonance) of the filter for the Lo and Hi
Pedal positions.
Gain Lo/Hi Set the gain of the filter for the Lo and Hi Pedal positions.
Filter Slope
selector
Allows you to choose between two filter slope values:
6
dB or 12 dB.