5.0

7
The included effect plug-ins
PingPongDelay
This is a stereo delay effect that alternates each delay re-
peat between the left and right channels. The effect can
either be tempo-based or use freely specified delay time
settings.
The parameters are as follows:
Distortion plug-ins
This section contains descriptions of the plug-ins in the
“Distortion” category.
AmpSimulator
AmpSimulator is a distortion effect, emulating the sound
of various types of guitar amp and speaker cabinet combi-
nations. A wide selection of amp and cabinet models is
available.
The parameters are as follows:
Parameter Description
Delay This is where you specify the base note value for the delay
if tempo sync is on (1/1–1/32, straight, triplet or dotted). If
tempo sync is off, it sets the delay time in milliseconds.
Tempo sync
on/off
The button below the Delay Time knob is used to turn
tempo sync on or off. If set to off, the delay time can be set
freely with the Delay Time knob, without sync to tempo.
Feedback This sets the number of repeats for the delay.
Filter Lo This filter affects the feedback loop and allows you to roll
off low frequencies up to 800Hz. The button below the
knob activates/deactivates the filter.
Filter Hi This filter affects the feedback loop and allows you to roll
off high frequencies from 20kHz down to 1.2kHz. The
button below the knob activates/deactivates the filter.
Spatial This parameter sets the stereo width for the left/right re-
peats. Turn clockwise for a more pronounced stereo
“ping-pong” effect.
Mix Sets the level balance between the dry signal and the
effect. If PingPongDelay is used as a send effect, this
should be set to maximum as you can control the dry/
effect balance with the send.
Parameter Description
Drive Governs the amount of amp overdrive.
Bass Tone control for the low frequencies.
Middle Tone control for the mid frequencies.
Treble Tone control for the high frequencies.
Presence Use this to boost or damp the higher frequencies.
Volume This controls the overall output level.
Amplifier
pop-up menu
This allows you to select between various amplifier mod-
els. Click on the currently selected amplifier name to
open a pop-up with all the available amplifier models.
This section can be bypassed by selecting “No Amp”.
Cabinet
pop-up menu
Various speaker cabinet models. Click on the currently se-
lected cabinet name to open a pop-up with all the available
amplifier models. This section can be bypassed by select-
ing “No Speaker”.
Damping Lo/Hi Further tone controls for shaping the sound of the selected
speaker cabinet. Click on the values, enter a new value
and press the [Enter] key.